2013 Mazda 6 service and repair manual — a detailed, factory-style reference for maintenance, diagnostics, and repair. Use it to confirm correct procedures, specifications, and system coverage before you start work.
Designed for technicians and DIY owners, this manual helps you diagnose issues correctly, follow proven repair steps, and use wiring diagrams and system sections to track faults faster.
What’s included
- Step-by-step repair procedures and service information
- Specifications and reference data (where provided)
- Electrical diagnostics with wiring diagrams
- Coverage across major systems: engine, transmission/driveline, brakes, steering, suspension, HVAC, and more
Trims covered
- i Sedan 4-Door
- GS Sedan 4-Door
- GT Sedan 4-Door
- S Sedan 4-Door
Engines covered
- 2.5L 2488CC 152Cu. In. l4 GAS DOHC Naturally Aspirated
- 3.7L 3726CC 227Cu. In. V6 GAS DOHC Naturally Aspirated
Index / Table of contents
- Body
- Brakes
- Chassis Electrical
- Driveline
- Engine Cooling
- Engine Electrical
- Engine Mechanical
- Engine Performance & Emission Controls
- Fuel System
- General Information & Identification
- Heating, Ventilation, & Air Conditioning
- Hybrid & Electric Vehicle Systems
- Steering
- Suspension
- Transmission, Clutch, & Transfer Case
- Wiring Diagrams
Mazda North American Operations (Mazda) is recalling certain 2014-2015 Mazda CX-9 vehicles sold, or ever registered in the states of Alabama, California, Florida, Georgia, Hawaii, Louisiana, Mississippi, South Carolina, Texas, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands or "Zone A." Additionally, unless covered in "Zone A," Mazda is recalling certain 2011-2013 Mazda6, 2011-2012 CX-7, and 2011-2015 CX-9 sold, or ever registered in the states of Arizona, Arkansas, Delaware, Illinois, Indiana, Kansas, Kentucky, Maryland, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Tennessee, Virginia, West Virginia and the District of Columbia, or "Zone B." Additionally, unless covered in Zone A or Zone B, Mazda is recalling certain 2010-2013 Mazda6, 2010-2012 CX-7, and 2010-2015 CX-9 vehicles ever registered in the states of Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin, and Wyoming or "Zone C." These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these inflators may explode due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.
An inflator explosion may result in sharp metal fragments striking the driver or other occupants resulting in serious injury or death.
Mazda will notify owners, and dealers will replace the front passenger air bag inflator with an alternate inflator, free of charge. The recall began November 9, 2018. Owners may contact Mazda customer service at 1-800-222-5500, Option 4. Mazda's number for this recall is 1317F.
Mazda North American Operations (Mazda) is recalling certain 2011-2013 Mazda6 vehicles sold, or ever registered in Connecticut, Delaware, the District of Columbia, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland,Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, and Wisconsin. The front cross member may corrode after exposure to road salt.
Corrosion may weaken the mounting point for the passenger side lower control arm, unexpectedly changing the steering alignment and increasing the risk of a crash.
Mazda will notify owners, and dealers will inspect the cross member and either install a side member and drain hose and apply wax to protect from rust, or install a drain hose and an improved front cross member, free of charge. The recall began June 13, 2019. Owners may contact Mazda customer service at 1-800-222-5500 Option 4. Mazda's number for this recall is 2818I. Note: This recall is an expansion of Recall 18V-631.
Mazda North American Operations (Mazda) is recalling certain 2013 Mazda6 and CX-9 vehicles sold, or ever registered in the states of Alabama, California, Florida, Georgia, Hawaii, Louisiana, Mississippi, South Carolina, Texas, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands or "Zone A." Additionally, unless covered in "Zone A," Mazda is recalling certain 2010 Mazda6, CX-7 and CX-9 vehicles sold, or ever registered in the states of Arizona, Arkansas, Delaware, District of Columbia, Illinois, Indiana, Kansas, Kentucky, Maryland, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Tennessee, Virginia, and West Virginia or "Zone B." Additionally, unless covered in Zone A or Zone B, Mazda is recalling certain 2009 Mazda6, CX-7, and CX-9 vehicles ever registered in the states of Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin, and Wyoming or "Zone C." These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these inflators may explode due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.
An inflator explosion may result in sharp metal fragments striking the driver or other occupants resulting in serious injury or death.
Mazda will notify owners, and dealers will replace the front passenger air bag inflator with an alternate inflator, free of charge. The recall began March 2, 2018. Owners may contact Mazda customer service at 1-800-222-5500. Mazda's number for this recall is 1317F.
Mazda is recalling certain model year 2009-2013 Mazda6 vehicles manufactured February 4, 2008, through August 24, 2012. The door latch mounting screws may become loose.
If all three door latch mounting screws become excessively loose the door latch mechanism would not engage and the door might open while the vehicle is in motion increasing the risk of accident or injury.
Mazda will notify owners, and dealers will apply a thread locking adhesive to the door screws and retorque them, free of charge. The recall began on October 29, 2013. Owners may contact Mazda at 1-800-222-5500. Mazda's recall number is 7013I.
This Service Alert supersedes the previously issued SA listed below: The changes are noted in Red. SA-011/24 02/12/24, 06/06/24, 07/29/24 DESCRIPTION Mazda has developed factory recommended scheduled maintenance services that support all ma
If you encounter any type of electrical concern (e.g, dead battery, engine no start, DTC(s) stored...), interview the customer before proceeding with normal MGSS diagnosis by asking if any aftermarket devices have been installed. Aftermarke
A musty/mildew type odor may come from the vents when the air conditioning (A/C) system is operating. It is most noticeable when the A/C is first turned ON. This odor is the result of mold growth in the A/C evaporator/cooling unit which is
Some vehicles may experience exterior trim heat damage such (melted, separating, etc.) when parked near a glass building or Low-E windows. This may be caused by the sun's reflection. If a structure's windows create enough of a curve, the co
When replacing the SiriusXM satellite radio unit, a call must be made to inform SiriusXM of the existing Radio ID and the new/replacement SAT Radio ID as soon as possible to ensure the customer leaves the dealership with an active SAT radio
Some customers may complain about a noisy HVAC blower motor or odor after a cabin air filter replacement. Foreign debris on the blower motor after servicing the cabin air filter may be the cause. During the removal of the cabin air filter,
A musty/mildew type odor may come from the vents when the air conditioning (A/C) system is operating. It is most noticeable when the A/C is first turned ON. This odor is the result of mold growth in the A/C evaporator/cooling unit which is
Some vehicles may experience exterior trim heat damage such (melted, separating, etc.) when parked near a glass building or Low-E windows. This may be caused by the sun's reflection.
Showing the 8 most recent of 161 technical service bulletins on file with NHTSA.
TAKATA RECALL AIRBAGS DID NOT DEPLOY WHEN HITTING ANOTHER VEHICLE WHILE GOING 35 MPH ON A BUSY HIGHWAY.*DT*JB
TL* THE CONTACT OWNS A 2013 MAZDA MAZDA6. THE CONTACT STATED THAT WHILE DRIVING 45 MPH, HE NOTICED A SPIDER RUNNING ACROSS THE DASHBOARD. THE CONTACT KILLED THE SPIDER BUT A FEW DAYS LATER, ANOTHER SPIDER EMERGED AND BIT THE DRIVER. THE VEHICLE WAS NOT TAKEN TO THE DEALER FOR INSPECTION. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE FAILURE MILEAGE WAS 13,000. UPATED 7/16/14*CN UPDATED 08/15/17*CN
The contact owns a 2013 Mazda Mazda6. The contact stated that the vehicle had been repaired under NHTSA Campaign Number: 18V631000 (Suspension, Structure) where a coating was sprayed on the passenger side lower control arm and the area was drained. After receiving the recall repair, the contact became aware that the vehicle was pulling to the right and the steering wheel was tilted to the left. The front passenger’s side tire was slightly turned inward. The vehicle was taken to a certified mechanic where it was diagnosed and determined that the front cross member on the passenger’s side was ru
I JUST BAUGHT A 2013 MAZDA6 THE REAR CRADEL AND CROSS MEMBER WAS COMPLETY RUSTED AWAY ONE MOUNT WAS COMPLETY RUSTED OFF .THE SPRINGS WAS ALMOST READY TO FALL OUT THE BOTTEM OF THE SPRING PURCH .IT LOOKED LIKE IT WAS PULLED OUT OF THE OCEAN WHERE IT HAD STAYED FOR YEARS .I TRIED TO FIND A USED REPLACEMENT OUT OF SEVERAL WE FOUND FROM 10-13 AND GOING THRU NATIONAL SALVAGE PARTS WE CAN NOT FIND ONE THAT WAS NOT RUSTY AWAY ALL THE MAZDA6 FRAMS WERE SO RUSTED THEY COULD NOT BE USED .WHY IS THIS NOT ON THE RECALL LIST IF ALL I COULD FIND ARE RUSTED OUT PARTS THAT IS A SAFTY HAZZARD TO HAVE ON THE RO
My car has approx 115,000 miles. I took it to Bass Mazda to have spark plugs and serpentine belt changed simply for maintenance purposes. After leaving dealership my car was pulling to the right. My steering wheel was no longer centered. It also was turned toward the right. Any time I had to hit the brakes the car pulled very hard to right. Long story short it we ended up finding out that my sub frame is very rusted and cracked. My car specifically does not fall into the recall for this issue. When I called mazda to inform them that this may be an issue with other cars the rep was ki d of rud
2013 Mazda 6 VIN [XXX] 1)Fuel tank leak. yes it is available for inspection 2)Gas leak with danger of fire or explosion. 3) Yes 4) No 5)Yes Reoccurring The 2014 Mazda 6 had a recall for the exact same problem I am having where the tank would overfill or if parked unlevel and it will activate a check engine light and "leak gas" out of the EVAP canister even while driving. The recall covered cars built between October 25, 2012 and May 9, 2013. My car was built 7-19-2012 and the dealer will not fix the issue. I have taken it to a dealer in Cincinnati and they said put a new fuel cap on it whic
was driving on the highway when the check engine light came on. not 10 minutes later, I lost acceleration and steering. managed to get to the shoulder just in time before my car pretty much died. the water light and battery light came on when I came to a stop. mechanic discribes it as 'catastrophic engine failure'. other than the check engine light, there were no other warnings. the temperature gage was normal and there were no weird sounds or smoke. diagnostic readings said a coolant leak lead to the radiator overheating which caused the engine to seize. the freeze frame data says 'P0117 engi
RELATED TO MAZDA RECALL NUMBER 2818I - FRONT FRAME ROTTING OUT. THEY APPLIED A BANDAID FIX UNDER THE RECALL, TO ONLY 1 SIDE OF THE VEHICLE AND THE PART THEY USED DOES NOT EVEN CONNECT TO THE ACTUAL SUSPENSION PIECES THAT ARE ROTTING OUT OF THE FRAME. IT IS BASICALLY A PLATE TO KEEP THE ROTTING FRAME FROM SEPARATING COMPLETELY ON ONLY 1 SIDE. THE PROBLEM IS THE ENTIRE FRAME IS STILL ROTTING AT A CRAZY EXCESSIVE RATE. I HAVE HAD MANY USED, OLDER VEHICLES AND HAVE NEVER SEEN A CAR SO NEW ALMOST RENDERED UNDRIVABLE DUE TO THE FRAME CONDITION. MY MECHANIC SAID IT SHOULD HAVE ALL BEEN REPLACED GIVEN
Showing the 8 most serious of 22 complaints filed with NHTSA.
