Massey Ferguson MF 475 Tractor Service & Repair Manual

The Massey Ferguson MF 475 Tractor service & repair manual is the complete 519-page factory workshop manual for this machine — with full step-by-step procedures, specifications, torque values, wiring and hydraulic diagrams and fault diagnosis.

What’s inside this manual:

• 1 - Presentation
• 2 - Safety
• 3 - Correct workshop techniques
• 4 - Basics of measurement
• 5 - General table of recommended torques for bolts
• 6 - Technical units
• 7 - Loctite products for the workshop
• 8 - AGCO environmental policy
• 9 - Compulsory recycling of batteries
• 1 - Introduction
• 2 - Splitting the tractor between the engine and the front axle
• 3 - Splitting the tractor between the engine and the gearbox
• 4 - Splitting the tractor between the gearbox and the rear axle
• 5 - ROPS + canopy + fender assy removal
• 6 - Front hood sheet metal removal
• 2 - Wheel alignment
• 3 - Front wheel hubs
• 4 - Outer arm and spindle shaft
• 5 - Front axle central beam
• 6 - MF 415 tractor axle
• 2 - Final drive
• 3 - Final drive pivoting
• 4 - Half-shaft spiders
• 5 - Bushingings and retainers of trumpets and pivots
• 6 - Pinion and differential assy
• 7 - Driving box and front bearing shell
• 8 - Steering cylinder
• 9 - Tightening torques
• 2 - Final drives
• 3 - Differential, pinion and trumpets
• 4 - Secondary drive box, brackets and bearings
• 5 - Mechanical-type side drive box
• 6 - Spacer and four-wheel central drive box
• 7 - Steering hydraulic cylinder
• 8 - Adjustment specifications
• 1 - Adjustment of valve tip clearance
• 2 - Nozzles inspection
• 3 - Adjustment of the injection point
• 4 - Compression test for cylinders
• 5 - Basic technical specifications
• 6 - Workshop specifications
• 1 - Types of clutches used on MF 400 Series tractors
• 2 - Clutches and flywheels fitted on the MF 400 Series tractors
• 3 - General information and recommendations about clutches
• 4 - Dual-stage and split-torque clutch: components identification
• 5 - Clutch removal and disassembly
• 6 - Inspection and refitment of the components
• 7 - Clutch reassembly (dual-stage and split-torque)

Built for real workshop use — the complete reference for keeping this machine running season after season.